Cartridge Heaters - Stainless Steel
|
|
Cartridge Heaters - All applications must consider fit tolerance, the correct watt density and appropriate terminal connections .
|
| |
| |
|
Ceramic Band Heater - All applications must consider the suitability of the diameter fit, mounting method, the correct watt density and appropriate terminal protection.
|
Ceramic Band Heater (Heaters)
|
Partial Coverage Band
Used around large obstruction which holes or cut outs cannot accommodate. 2 piece construction with barrel nuts. shown. Others available.
|
|
| |
|
Right angle armor cable with fiberglass leads
Specify location and length of leads at time of order.
|
|
| |
|
| Shell Overlap
The metal strap is continued over the gap and a hole is provided. This allows for thermocouple mounting without a hole in the heater. |
|
| |
|
Armor cable with fiberglass leads
Specify location and length of leads at time of order. |
|
| |
|
Metal braid with fiberglass leads
Specify location and length of leads at time of order. |
|
| |
|
Fiberglass leads with protective sleeve
Specify location and length of leads at time of order.
|
 |
| Ceramic Band Heater (Heaters) - Terminals |
|
|
10-32 Threaded Terminals
Minimum width required 7/8"
|
|
10-32 Threaded Terminals
Minimum width required 7/8"
Specify location at time of order.
|
 |
10-32 Threaded Terminals
Minimum width required 2.00"
Specify location at time of order. |
 |
Ceramic Terminal Covers
Available on all threaded terminals. Covers available separately. |
 |
Sheet Metal Terminal Box
Available with T2 and T3 threaded terminals. |
 |
10-32 Threaded Terminals
Minimum width required 7/8"
Specify location at time of order. |
 |
